FPVMODEL Betaflight BFF3 AIO F3 Flight Controller


Betaflight F3 AIO Flight Controller (PDB, Osd, Current Sensor, SD Card Reader) BFF3

BetaflightF3 AIO Flight Controller

RCGroups Thread for the BetaflightF3 Click Here

Special Features

  • Designed with direct input from Boris of betaflight
  • Dshot compatible and tested by the developer
  • Output 5V or 3.3v for Spektrum guys
  • All In One Flight Controller with, Regulators, PDB, OSD & Current Sensor
  • Massive 3 amp regulator built in to power all your VTX, Camera, LEDs etc
  • Removable microsd card allowing perfect black box tuning.

BetaflightF3 is the flight controller designed to use every possible feature of Betaflight for a super-tight super-clean build.
More than the last half of 2016 was been spent in development. Boris B has worked with FPVMODEL to go over features and design aspects to help give us insight into what betaflight users want/need.

This board features a 3A power draw giving users extra room for added attachments through uart ports. The six layer PCB is a more expensive design approach but was needed to give the ability to have a PDB that was capable of having wiring pads on both the top and bottom of the board. By using the six layer design we were able to increase the size of the pads and work around all the components all the while giving esc connections in the corners of the board rather than bunching all connections on either the top OR the bottom.

Featuring a fully functioning OSD that can be configured in Betaflight this board will make configuring your OSD a breeze.

The team at betaflight have been hard at work developing DSHOT and this board is also compatible with the latest release. But we didn’t stop there, this board also features a micro adapter to accept TF cards for those of you that like to follow up your flights with reviewing black box logging...we think we know of at least one guy that will like that.

Friendly Reminder: Choosing your power supply for video is relatively simple. Betaflight FC has two options, 5v and battery voltage. Choose your camera voltage by jumping RAM with either the 5V solder section or the Vbat solder section. (its recommended to use Vbat, Most cameras and Video transmitters can run off battery voltage) If using 5v it is recommeded to only power your camera and get the power for Vtx from another source.

BetaflightF3 AIO Flight Controller Pin Out

To visit the parent listing on FPVModel.com's website, Click Here.

Bf3, Bff3, Betaflight F3 Flight  Controller

Category: Flight Controller

Type: Electronics